Masonry damage can be a real eyesore. Not only does it look bad, but it can also lead to further damage if not fixed quickly. In this blog post, we will discuss how to fix mortar damage with tuckpointing. Tuckpointing is a masonry repair technique that involves filling in the joints between masonry units with mortar. It is a quick and easy way to restore the appearance of your masonry and prevent further damage from occurring. So, if you are dealing with mortar damage, be sure to give tuckpointing a try.Tuckpointing is a masonry repair technique that involves filling in the joints between masonry units with mortar. The mortar used for tuckpointing is typically composed of Portland cement, sand, and water. It is mixed to a consistency that is similar to that of peanut butter.If you mortar is cracked, crumbling, or otherwise damaged, it will need to be repaired. In some cases, the damage may be so severe that the masonry units will need to be replaced.Tuckpointing is typically only necessary every few years. However, if your masonry is exposed to a lot of wear and tear, it may need to be done more frequently. Tuckpointing is usually necessary once every 25 years or so.When tuckpointing mortar, it is important to use a color that closely matches the existing mortar. This will help to blend in the repair and make it less noticeable.Tuckpointing is a relatively simple process, but it does require some time and effort. If you are not comfortable doing it yourself, you can hire a mason to do the work for you.The cost of tuckpointing will vary depending on the size and scope of the project. However, it is generally an affordable repair option.The first step in repairing mortar damage is to remove all of the loose and damaged mortar from the joints. This can be done with a chisel and hammer or by using a power washer. Once all of the loose mortar has been removed, the joints should be cleaned out with a wire brush.After the joints have been cleaned out, they should be wetted down with water. This will help to prevent the new mortar from drying too quickly. Next, the new mortar should be mixed and applied to the joints. It is important to make sure that the new mortar is the same color as the existing mortar. Otherwise, it will be very noticeable.Once the new mortar has been applied, it should be allowed to dry for 24 hours before being used.